| temperature controller and thermocouple sensor that can be integrated with Watlow silicone rubber heater products. This device senses the temperature via input from a thermocouple placed strategically on the heater mat. The microprocessor is programmed prior to shipment with the customer's application-specific set point. This results in quick delivery of a custom integrated system.
The small mass of the thermocouple provides superior response to changes in process temperature and allows for higher watt density silicone rubber heater designs. Depending on the specific application, Watlow's power switching can extend life up to 40 times greater than thermostats. These features result in an integrated custom set point temperature control product with superior life span, faster heat-up rates and improved accuracy. The SERIES EHG system has been tested to over four million cycles at rated amperage.
Features and Benefits
Long operational life
Improves system reliability
Tight temperature control
Assures process accuracy
Small sensor footprint
Fits with almost any heater
Responds quickly to temperature changes
Controls high watt densities in low mass applications
UL® recognized
Compliant with agency regulations
Reduced system cost
A single EHG controller can be configured with multiple heaters to reduce system cost
Pre-wired, in line controller
Simplifies installation
Two-wire power connection
Durable housing with built-in strain relief
Protects electronics
Low risk of mechanical damage
Manufactured with proven Watlow components
Assures reliable system performance
Applications
Aerospace composite repair
Foodservice equipment
Freeze protection
Life sciences
Semiconductor
Telecommunications
UL® and C-UL® are registered trademarks of Underwriter's Laboratories, Inc. | 
